When the mountain bike is made 700c, the noted necessary point is a point that 700c wheel for loading cannot use the state as it is.
Because the mountain bike is the much more when the width of a rear end is loading because though it is 130mm question ..neglecting.. 135mm, the use turning is impossible.
Therefore, it is necessary to buy the wheel for the crossbike as it is a mountain bike united from trying the union of the hub by 135mm only for the mountain bike or the beginning by 135mm.
It seems to be able to use it also with the wheel for loading by exchanging parts of a part of hub in back [waza] and using the washer etc. instead of the spacer as it is worth.
However, I think that you should not put out your hand in such a method back [waza] if it is possible to do when there is not so much confidence that it is possible to deal with the trouble.
Or, still when it is “Perhaps, even if it bends, the frame must be about 5mm safe” though it might be good.
However, even if this actually executes and becomes a trouble by any chance, it cannot assume all the responsibilities.
I hope in the self-responsibility therefore.
The tire seems to be likely to interfere in the frame when making it to 700c wheel with it and the frame.
The wheel of 700c is able not to be used for all mountain bikes absolutely either.
Being not able to say that it doesn’t actually match around here indescribably might be an honest point.