Flow of tire exchanges of mountain bikes

The tire exchanges of mountain bikes ･･･ Can you do correct and smoothly?
Isn’t there “The [imaichi] way is not understood though tires are exchanged for the first time”?
The tool necessary for the tire exchanges of mountain bikes is a floor pump (A portable pump is not cared either), a tyre lever, a replacement tire, and a tube for the exchange.
Then, let’s concretely chase the flow of the tire exchange.
[Masuha] and the tire are removed.
All nuts etc. of the valve are removed, the tyre lever is inserted, it detaches from the wheel of one of tire beads, and the lever ..spoke.. is stopped.
Let’s insert the second tyre lever this time, remove the tire bead, and stop it to the spoke.
The first tyre lever is pulled out, and opened on the tip of the second tyre lever ･･･ When it finishes removing the tire that repeats the operation several times to some degree, the lever is not used, the finger is inserted, and it removes.
Please take out the tube with it does, the one side of the tire is removed, and the part of the valve left.
It is OK if the tire in the remainder at the end is made [ne] [ru] way and it removes.
The tire is continuously installed.
Please pass the valve of the tube through the hole of the wheel, and fix one of entire tire beads into the wheel.
And, the tube is put in the tire, and the tire bead in the remainder is fixed from opposite of the valve sequentially.
Next, let’s vertically move the valve and adjust for the tube not to be placed between wheels of the tire bead.
It is another breath.
The nut air of the valve is put a little, and whether the tire has been evenly stored in the wheel is confirmed.
When be not even it, deflate once, and try to massage it by the hand.
Finally, air is put enough, and the end of the cap in all.